Product Details

AWS B2.2/B2.2M:2010


AWS B2.2/B2.2M:2010

Specification for Brazing Procedure and Performance Qualification
Edition: 3rd
American Welding Society / 07-Jul-2009 / 86 pages
This specification provides the requirements for qualification of Brazing Procedure Specifications (BPSs). This specification also provides requirements for the performance qualification of brazers and brazing operators. This specification is intended for use where referenced by a product standard or contract document.
Employers shall be responsible for the brazing done by their organization, including the use of qualified brazing procedures, qualified brazers, and qualified brazing operators. It is the Employer芒鈧劉s responsibility to assure that Brazing Procedure Specifications meet any additional requirements of the Referencing Document. Each Employer shall maintain
the applicable Brazing Procedure Specifications, Brazing Procedure Qualification Records (BPQRs), and Brazing Performance Qualification Records during the period of their use.
When not otherwise specified by the Referencing Document, the edition of this specification to be used shall be established in accordance with the following: (1) editions may be used at any time after the effective date of issue; (2) the latest
edition of this document should be used for new contracts; (3) editions established by contract date may be used during the entire term of the contract, or the provisions of later editions may be used when agreed upon by the contracting parties.
This document is intended primarily for use with the following brazing processes:
(1) Torch Brazing (TB)
(2) Furnace Brazing (FB)
(3) Induction Brazing (IB)
(4) Resistance Brazing (RB)
(5) Dip Brazing (DB)
(6) Infrared Brazing (IRB)
(7) Diffusion Brazing (DFB)
This standard makes use of both U.S. Customary Units and the International System of Units (SI). The latter are shown within brackets ([ ]) or in appropriate columns in tables and figures. The measurements may not be exact equivalents; therefore, each system must be used independently.
Safety and health issues and concerns are beyond the scope of this standard and therefore are not fully addressed herein.Safety and health information is available from other sources, including, but not limited to, ANSI Z49.1, Safety in Welding, Cutting, and Allied Processes, and applicable federal, state, and local regulations.

Please Choose:


Add to Cart: