Product Details

ASME B18.2.2-2010

$17.00

ASME B18.2.2-2010

Nuts for General Applications: Machine Screw Nuts, Hex, Square, Hex Flange, and Coupling Nuts (Inch Series)
American Society of Mechanical Engineers / 30-Nov-2010 / 38 pages
INTRODUCTION
1.1 Scope
1.1.1 This Standard is intended to cover the complete general and dimensional data for the various types of inch series square and hex nuts, including machine screw nuts and coupling nuts, recognized as American National Standard. Also included are appendices covering gaging of slots in slotted nuts, wrench openings for nuts, and formulas on which dimensional data are based. It should be understood, however, that where questions arise concerning acceptance of product, the dimensions in the tables shall govern over recalculation by formula.
1.1.2 The inclusion of dimensional data in this Standard is not intended to imply that all of the products described herein are stock production sizes. Consumers are requested to consult with manufacturers concerning lists of stock production sizes.
1.2 Comparison to ISO Standards
There are no comparable ISO inch fastener standards.
1.3 Dimensions
Unless otherwise indicated, units of measurement are expressed in inches.
1.4 Options
Where options are allowed, they shall be selected at the manufacturer’s discretion unless otherwise specified by the purchaser.
1.5 Terminology References
For definitions of terminology not specifically defined in this Standard, refer to ASME B18.12.

Please Choose:

Documentation




Add to Cart: